Vacuum Top Coat Touch-Up Gun

- For use with MILSPRAY Touch-Up Paint

MILSPRAY's revolutionary vacuum touch-up system was designed to apply low voc, high solids military coatings. It combines the principals of fluid dynamics and the Bernoulli effect and yields transfer efficiencies greater than any other application system of its type. The heart of the system is a die cast one piece handle that has a precision pathway bored through a solid metal housing. This results in reduced friction, less air turbulence, less wall friction, and fewer obstructions. In fact, the vacuum gun contains none of the parts found in a typical spray gun because it is not a spray gun. There are no needles, springs, flow regulators or other parts found in a traditional spray gun system.

Utilizing MILSPRAY's 2 ounce bottles, a vacuum is created within the bottle, and the material is actually pulled from the bottle and transferred to the substrate. Since no air is mixed with the paint it does not actually atomize. There is no blow back, no overspray, and no Hazardous Air Pollutants (HAPS). Extremely low air pressure is required to create the vacuum - approximately 9-15 psi. It can be connected to any compressor or air line.

The vacuum gun has "system limiters" and fixed factory settings. There are no flow or volume controls and no way to increase the amount of coating that can be dispensed through the vacuum gun. Additionally, the vacuum gun only accepts MILSPRAY touch-up bottles and will not work with any larger capacity cups or bottles. This ensures that the system is used for its intended purpose - touch-up.